Flowline LI40-1001 PodView User Manual

Page 11

Text mode
Original mode

Rev A

MN204260

11 of 16

INSTALLATION

Step Seven

PodView® is designed for typical panel mount installations, either located within an instrument panel or
through the wall of a NEMA box enclosure.

Panel Mount: The maximum cable distance between PodView® and EchoPod® is 15’ (4.5m). Follow the below
steps to install the indicator in a panel or NEMA box enclosure located near EchoPod®:

1. Drill (1) large 0.75” (19.1mm) diameter hole in the

panel for the cable and nipple.

2. Drill (1) small 0.25” (6.4mm) diameter hole 0.83”

(21.1mm) below the large hole that will prevent
the installed indicator from rotating off center.

3. Run the indicator cable through the large top hole

and locking nut (on the rear side of the panel).

4. Properly align the indicator with the flat gasket

and holes on the panel. Then press the indicator
in place against the panel.

Tighten the locking nut down over the nipple and
route the cable for termination.