Flowline LI40-1001 PodView User Manual
Page 15
Rev A
MN204260
15 of 16
TROUBLESHOOTING
Step Nine
Display Descriptors: The following are the display’s operational descriptors, meaning and corrective action:
WARMUP
WARMUP is seen when power is first applied to the EchoPod® and PodView®. WARMUP
indicates that the display is waiting for the EchoPod® to acquire and send a valid level
reading.
MENU
Indicates the menu for configuration of relay set points.
PUMP
PUMP is the identifier for the relay set points affecting Pump or Valve operations.
OFF
OFF is the relay set point that turns OFF the pump.
ON
ON is the relay set point that turns ON the pump.
LAG
LAG is the set point that turns ON the lag pump.
ALARM
Alarm is the identifier for the relay set points affecting Alarm operations.
HIGH #
HIGH # is the relay set point that energizes a high alarm relay.
LOW #
LOW # is the relay set point that energizes a low alarm relay.
CHECK WIRES
Not All four wires are properly connected to the EchoPod®. Check the wiring between the
PodView® and the EchoPod®.
UPDATE FW REV
The attached EchoPod® is not running a version of the firmware (50.0 or higher) that is
compatible with PodView®. Connect the EchoPod® to WebCal® 6.0 and update the
firmware.