Flowline DL34 EchoPod - Manual (Page 13)

31 MAR 11 EchoPod 13 of 29
Rev B MN204210
Relay Fail-Safe
This feature allows you to select the fail-safe state for the relays.
When the sensor regains signal, the output current will revert back to
the current level condition.
o Relays Off - The relays will revert to the OFF state. Appears
when Switch/Alarms Only is selected.
o Relays On - The relays will revert to the ON state.
Appears when Switch/Alarms Only is selected.
o Hold State - The relay(s) will remain in the same state as the
last echo detected. When the sensor regains signal, the relays
will revert to the level when the signal was regain.
o Pump/Valves Off - The relays will revert to the OFF state.
Appears when 1-Pump/Valve or 2-Pumps/Valves are
selected.
o Pump/Valves On - The relays will revert to the ON state.
Appears when 1-Pump/Valve or 2-Pumps/Valves are
selected.
o Not Applicable – Appears when this function is not available
(such as when Transmitters Only are selected).
Note: Right click on any menu that you may have questions on to open the help menu.
Note: To reset, press the Clear Screen button.