EXP Computer HD TRAVELER E PCMCIA (including Win 2000 XP) - Manual (Page 20)

- 14 -
SOFTWARE INSTALLATION FOR WINDOWS XP
1. Boot-up your computer into Windows, making
sure the device driver for ‘PCMCIA Adapters’
has been installed and is available. To check this,
right-click ‘My Computer’, click ‘Properties’
then ‘Hardware’ and then ‘Device Manager’ to
open the ‘Device Manager’ window. Refer to the
figure shown alongside to see if the PCMCIA
Controller is installed without error.
2. Ensure the PCMCIA interface cable and then the external power connections (if you are using the
external power) are made as described in Hardware Installation. Slowly insert the PC Card of
interface cable into the PCMCIA socket of computer and press firmly until the connector is seated
(Please note that the PC Card is keyed to guide for proper insertion).
3. Windows will find a new hardware
named ‘PCMCIA PnPIDE’, and start
up the ‘Found New Hardware Wizard’.
On the first screen, select ‘Install the
software automatically’, insert the
driver diskette into floppy drive, and
then click Next.