EXP Computer HD TRAVELER E PCMCIA (including Win 2000 XP) - Manual (Page 17)

- 11 -
SOFTWARE INSTALLATION FOR WINDOWS 2000
1. Boot-up your computer into Windows, making sure
the device driver for ‘PCMCIA Adapters’ has been
installed and is available. To check this, right-click
‘My Computer’, click ‘Properties’ then ‘Hardware’
and then ‘Device Manager’ to open the ‘Device
Manager’ window. Refer to the figure shown
alongside to see if the PCMCIA Controller is installed without error.
2. Ensure the PCMCIA interface cable and then the external power connections (if you are using the
external power) are made as described in Hardware Installation. Slowly insert the PC Card of
interface cable into the PCMCIA socket of computer and press firmly until the connector is seated
(Please note that the PC Card is keyed to guide for proper insertion).
3. Windows will find a new hardware named ‘PCMCIA PnPIDE’, and start up the ‘Found New
Hardware Wizard’, click Next on the first screen.
4. On this screen, select ‘Search for a suitable
driver for my device (Recommended)’,
click Next.