EXP Computer HD TRAVELER E PCMCIA (including Win 2000 XP) - Manual (Page 10)

- 4 -
HARDWARE INSTALLATION
Note:
♦ If you want to use an external power to powers the hard disk, please use the AC adapter or PS/2
power source cable provided by manufacturer, using an incorrect external power could result in
permanent and unpredictable damage to the drive.
♦ This external hard disk supports Hot Insert/Remove function only under Windows
95/98/Me/2000/XP, with the other operating systems, please insert the PC Card of interface
cable before power-on computer, and remove this card after power-off computer.
1. Insert the plug of the PCMCIA interface cable into the Interface Connector of drive. Press firmly
until the interface connector is seated correctly.
2. Make sure the Power Source Switch is at the correct position.
PC: get power from the PCMCIA socket of computer.
DC: get power from the external power.
Note: If you are using an external power to powers the external hard disk, the sequence is,
change the Power Source Switch to ‘DC’ position, then connect the external power to the
External Power Jack of the drive, and attach the external power to the outlet.
3. You are now ready to install the device drivers, please follow the related software installation guide
to install the device driver.