EXP Computer CDG Game Upgrade - Manual (Page 3)

INSTALLING THE CD-ROM WITH THE GAME PORT ADAPTER
1. Connect the game adapter to your CD-ROM drive, and tighten the two
screws on the game adapter.
2. Connect a joystick or game-pad to game port
3. Connect the PCMCIA interface card to the Game Adapter, and then
tighten the two screws on the cable connector.
4. Place your CD-ROM drive in the horizontal position. Your CD-ROM drive
is designed to operate only in the horizontal position. Operating the CD-
ROM drive in any abnormal position is not recommended.
5. Locate the PCMCIA slot on your computer or consult your computer user’s
manual for its location.
6. Align the PCMCIA interface card with the arrow sign pointing toward the
computer’s slot. (Please note that the card is keyed to guide for proper
insertion.)
7. Slowly insert the PCMCIA interface card into the slot and press firmly until
the connector is seated.
8. Turn your system ON and install the CD TRAVELER device driver. Please
follow the Software Installation procedures to follow.
SOFTWARE INSTALLATION FOR DOS/WINDOWS 3.1
AUTOMATIC INSTALLATION
This INSTALL program helps you install the device driver into your computer
easily. Please follow the instructions below to proceed with the automatic
installation.
1. Insert the device driver diskette into the floppy disk drive on your
computer
2. Change the working directory to the floppy drive containing the device
driver diskette by typing “ A: ” or “ B: ”, then press ENTER.
3. At the DOS prompt (A:\> or B:\>), type “ INSTALL ” followed by the ENTER
key.
4. Press ENTER or click on the OK button to continue. When the opening
screen appears, a dialog box will be displayed for you to specify the 1),
directory to install the device driver to; 2), the DOS directory to specify
the location of the MSCDEX driver, and 3), the I/O port desired for the
CD-ROM. Enter the directory you want to install the driver to and press
the TAB key to forward to the next field to indicate the DOS Directory.
Press the TAB key again to set the I/O port. The default setting for the I/O
ports are (320-32F and 200-207). After completing the selections, click on
the Install button to continue.