Dynasonics D300_301 Series Doppler Ultrasonic Flow Meter - Manual (Page 17)

Rev. 2/00 -3.3- 300/301
with wire markings. Connect the appropriate wires
to the corresponding screw terminals in the
transmitter. See the electrical connections detail in
Figure 3.2 and 3.3.
NOTE: The transducer cable carries low level
signals. Do not attempt to add additional cable to the
factory supplied transducer cable. If additional cable
is required, contact the Dynasonics factory to arrange
for an exchange transducer with the appropriate
length of cable. Cables to 300 feet [ 90 meters ] are
available.
PART 3 - TRANSMITTER INSTALLATION