Datamax-O'Neil S-Class DTPL Programmer’s Manual - Manual (Page 12)

DTPL Programmer’s Manual 6
Command Format Description
No Status or Disables the transmission of all status information, except for x-on/off information.
Parking Ticket Command or Reverses the ticket to the print position after the last ticket in a group has been printed.
Partial ASCII Status or All status information, except for a valid xon/xoff, will have 30h added to them to
convert them to an ASCII value.
Pcx File Being Sent
Command Notifies the printer that a PCX image file is being sent to the printer.
Print Downloadable Font
Command Use this font command to specify the desired font.
Print Downloadable Logo
Command The Printer prints one of its customer-downloaded logos on the ticket.
Print Intensity Adjusts the print intensity at a given speed setting. The # value may range from –5 to +5.
Print Resident Logo
Command Causes the Printer to print any one of its factory pre-loaded logos on the ticket.
Print Ticket Count
Command Prints the total amount of tickets printed on that printer.
Prom Type And Ticket
Count Status Request The printer will respond with a seven-digit ticket count followed by the software level of
the printer.
Purge Printer Of
Remaining Tickets
Command In this mode, when the printer runs out of tickets it will purge all remaining ticket
information. It will also reset the ticket count to zero.
Scale Down Command Fonts will be divided by the # indicated in the scale down command.
Shade Pattern # The number sent is the pattern that you want to shade with. Pattern #
0 - white 13 - light medium fine dot pattern
1 - very light course dot pattern 14 - medium fine dot pattern
2 - light course dot pattern 15 - dark - medium fine dot pattern
3 - light - medium course dot pattern 16 - dark fine dot pattern
4 - medium course dot pattern 17 - open
5 - dark - medium course dot pattern 18 - open
6 - dark course dot pattern 19 - black
7 - open 20 - vertical lines
8 - open 21 - horizontal lines
9 - black 22 - forward diagonal lines
10 - white 23 - backward diagonal lines
11 - very light fine dot pattern 24 - square grid
12 - light fine dot pattern 25 - diagonal grid
Shade Pattern In
Background Sets the shading to occur in the background.
Shade Pattern In
Foreground Sets the shading to occur in the foreground.
Starting Point Command Assigns the starting location of the logo.
Status Request Instructs the printer to respond with a one byte status message.
Test Button Disabled
Command Disables the test button on the printer.
Test Button Enabled
Command Enables the test button on the printer.