Resetting the printer, Bluetooth setup – Datamax-O'Neil RL3_4 User Guide User Manual
Page 56
B-8
B
B
B
.
.
.
5
5
5
R
R
R
e
e
e
s
s
s
e
e
e
t
t
t
t
t
t
i
i
i
n
n
n
g
g
g
t
t
t
h
h
h
e
e
e
P
P
P
r
r
r
i
i
i
n
n
n
t
t
t
e
e
e
r
r
r
In the event of a Wireless LAN communication problem (drop offs, hangs, can’t communicate, ect..), the
printer can be reset.
To reset the printer:
1) Press and hold the
button until the “Radio Off” message is displayed and then release.
2) Next, press and hold the
button until the “Turning Radio On” message is displayed and then
release.
The printer will re-boot and attempt to connect to the network device using the parameters previously
set in the printer.
As an alternate method, remove the battery from the printer, wait 20 seconds, and then re-install the
battery, see section 2.1.
B
B
B
.
.
.
6
6
6
B
B
B
l
l
l
u
u
u
e
e
e
t
t
t
o
o
o
o
o
o
t
t
t
h
h
h
S
S
S
e
e
e
t
t
t
u
u
u
p
p
p
The printer is configured with default factory settings. To determine your printer's configuration, print a
Configuration Label, (see Section 3.2).
1) Click the Bluetooth menu item in the
Printer Component section of the
configuration utility.
2) To set up the printer for Bluetooth, change
(or confirm) the following parameter
settings:
Bondable: Yes
Connectable: Yes
Discoverable: Yes
PassKey: Default ‘0000’ (must match
entry used on host computer)
3) After updating the “New Value” column,
click the Send button to send these
changes to the printer.
4) Allow 30 seconds for the printer reset. For
connection to the printer please refer to
the instructions included with your
Bluetooth adapter or host
computer/handheld.