Datamax-O'Neil RL3_4 User Guide - Manual (Page 50)

B-2
B B B . . . 2 2 2 S S S t t t a a a t t t i i i c c c I I I P P P / / / D D D H H H C C C P P P S S S e e e t t t t t t i i i n n n g g g
The printer can be configured to use a static IP or an dynamic IP obtained from a DHCP server.
Using a Dynamic IP Address (DHCP):
1) Click on the ‘Wireless General
Network’ printer component.
2) Change (or confirm) the
following parameter setting:
IP address method: DHCP
3) After updating the “New Value”
column, click the Send button
to send these changes to the
printer.
 Values obtained from the DHCP server will be shown under the fields: Active IP address, Active
Subnet Mask and Active Gateway.
Using Static IP Address:
1) Click on the ‘Wireless General
Network’ printer component.
2) Change (or confirm) the
following parameter settings:
IP address method: Static
Static IP address: According to
your network IP range.
Static Subnet mask: According
to your network subnet mask.
3) After updating the “New Value”
column, click the Send button
to send these changes to the
printer.