Datamax-O'Neil H-Class Powered Internal Rewind Option - Manual (Page 9)

7
Removing Stock from the Internal Rewinder
The Internal Rewinder allows you to wind an 8-inch (203 mm) outer diameter roll of media or liner.
Proceed according to your application to remove material from the rewinder:

To remove rolled media, open the Latch on the Media Retainer, remove the Media Retainer, and then
slip the rolled media and core off the Core Adapter; or,

To remove rolled liner material, grasp the roll, squeeze, pull, and slip the liner off the Rewinder Hub.
Changing Applications
If your application for the Internal Rewinder changes, proceed according to the printer’s current
configuration to add or remove components as necessary:

If you are currently winding labels onto a media core but want to begin winding liner material directly
onto the hub, open the Latch and remove the Label Retainer. Carefully slide the Core Adapter off the
Rewinder Hub (use a slight rocking motion, if necessary). Afterward, reference Step 3 (above) to
wind onto the hub; or,

If you are currently winding liner material onto the hub but want to begin winding labels onto a media
core, install the necessary components, starting with Step 2, part d (above).