Datamax-O'Neil H-Class Powered Internal Rewind Option User Manual

Page 7

B) Load Media as you normally would, but extend

about 20 inches (50 cm) of it from the printer –

then proceed according to your application:

Media



To wind onto a Media Core –

Follow the directional arrows on the Core

Adapter and wrap the Media in a

counterclockwise direction around the

Media Core then secure the leading edge

using Tape. Rotate the Hub by hand to

take up any slack in the media. There

should be at least 2 or 3 full wraps of the

media on the empty core before starting

printing to ensure tight rewinded rolls.

Media

(Labels & Liner)

Tape

Media

Core

Adapter



To wind onto the Rewinder Hub –

Remove the labels from the extended

portion of media and crease the leading

edge of this Liner Material.

Wrap

the

Liner Material in a

counterclockwise direction around the

Rewinder Hub and insert the creased

leading edge into one of its Slots. Insert

the Media Clasp (Item

) into the Slot

over the creased leading edge of the

Liner Material and around the Rewinder

Hub.

Rewinder

Hub

Media
Clasp

Liner

Material

Slots

creased

leading edge