BEI Sensors 9360 - Manual (Page 2)

Mechanical Specifi cations
Mechanical travel 0° to +360° with no stops, allowing for infi nite rotations
Frequency response 1,000Hz minimum
Rotational torque 0.025 – 0.110 N-m
Weight 35 grams (approx.)
Electrical Specifi cations
Mechanical input range 0° to +360° (other, custom limited angle ranges available)
Input voltage 5.0 V±0.25V DC
Input current 18mA maximum per output
36mA maximum total (both channels)
Sensor 0.25V – 4.75V for Analog at 5.0V input
5% – 95% duty cycle for PWM
(Different outputs and mechanical range(s) available as a custom option)
Accuracy ±0.6% of full scale at room temperature
±0.9% of full scale over operating temperature range
Resolution Analog (continuous)
Environmental Specifi cations
Electromagnetic compatibility 100V/meter, 14kHz – 1GHz range
Vibration 10G peak, 20 – 2,000 Hz
Shock 50Gs, half sine pulse, 5 m sec duration
Side load 1kg for 1 million cycles
Operating temperature range -40°C to +85°C
(wider operating temperature -40° to +125 C° available)
Storage temperature range -55°C to +105°C
© Copyright 2007 BEI Duncan Electronics. Specifi cations subject to change without notice.
ISO9001 & TS16949 Certifi ed
170 Technology Drive West
Irvine, CA 92618-2401
(949) 341-9530 Fax: (949) 453-2700
email: [email protected]
www.beiduncan.com
9360
Series
Note: All dimensions are shown in millimeters
Note 1 : Shaft is positioned at 50% voltage output
360° Non-Contacting Rotary
Dual Output Hall Effect Sensor
CONNECTOR PIN OUTPUT
SENSOR 1 SENSOR 2
Vs (INPUT) F B
GROUND E A
OUTPUT C D