Delta Controls DPR-2000 - Manual (Page 24)

A 22 IOM-DPCDPR-A: FEB 2014
If the option of local configuration is active, operator can change transmitter set using buttons being below
display. The access to buttons will get after unscrewing the side cover. Then we can also change the display
position turning it with 90
0 angle position. (see fig. 4).
If the option of local configuration is active, operator can change transmitter set using buttons being below
display. To enter at the local set change of the work mode, you should press one button and hold its about 4s.
If using buttons can't change the transmitter configuration , the local transmitter configuration is switched of and
to its switching on is necessary to use the KAP 3 Calibrator.
The buttons are signed with symbols:
[↑] [↓] [◙]
After pressing by 4 seconds any of buttons there will appear on display
“EXIT”.
If we will confirm this announcement across pressing and holding button [[◙] by 1 sec, we will go out from the
local change of the MENU set. If we will not confirm, we can move in MENU and change interesting us
parameters. The time of pressing [↑]] [↓] [◙] has to be longer than 1s.
Pressing button [↑] moves up in tree's structure MENU
Pressing button [↓] moves down in tree's structure MENU
Pressing [◙]confirms choice and leads change.
|
EXIT
(First announcement which will see after inclusion of Menu Local.
| If you will confirm this option, you will go out from Local Menu
| and you will come back to continue of measuring)
PV ZERO_________
\
| BACK (Return to Local Menu. If you will confirm this option,
| | you will come back to main tree of Local Menu)
| |
| |
| PV ZERO (Pressure zeroing. If you will confirm this option,
| transmitter will confirm the party of command
| by the "DONE" announcement or the proper number of error will
| notify.)
|
SET LRV_________
(The Setting of the range of the set LRV beginning) -(no change of span)
| \
| BACK (Return to Local Menu. If you will confirm this option,
| | you will come back to main tree of Local Menu)
| |
| BY PRESsure (Setting LRV across setting pressure. If you will confirm this
| | option, transmitter will confirm the party of command by the
| | "DONE" announcement or the proper number of error will notify)
| |
| BY VALUE (Setting the LRV across inscribing of value.)
(After confirmation will display current LRV value before the passage
in mode of edition)
| ↓
| ↓
| +/- (Choose and confirm sign introduced parameter)
| ↓
|
00000 (Introduce in sequence , digit after digit, 5 digital number with point
| or without point. After confirmation the last 5 digit of the parameter
| transmitter will confirm the party of command by the "DONE"
| announcement or the proper number of error will notify.
| The parameter will be written down in units "UNIT")
|