Delta Controls 2HTDCAL - Manual (Page 4)

DOCUMENT CONVENTIONS
This manual uses the following typographical conventions to describe the functionality of the
transmitter. The blind instrument has two buttons, marked ZERO and SPAN. The D-CAL has two
buttons, marked SELECT (SAVE) and CHANGE
When the keys, or functions, are discussed within the text they will be referred to by their name in
lower case, without brackets. The zero and span buttons are mounted on the upper board,
while the select and change buttons are part of the display module.
3
Convention Description Function
[ZERO] [SPAN] Bold and bracketed
denotes a single
operation of a key.
Press and hold for
around two seconds Used to set the LRV and URV of
the blind transmitter
[SELECT]
[CHANGE]
Denotes a single, short
operation of a key on
the local display unit Used to navigate the menu
system, and request a change to
an entry.
[[SELECT]] Bold and double
bracketed
Press and hold for
around two seconds
The save function used to store a
change to the EEprom
The screen will respond with
{SAVED}
{MENU} The menu option
bracketed, e.g.
{RANGELO} Used within this manual to show
how a command or other
message is displayed within the
menu.
{ ACCESS 2}
{ACCESS 2}[SELECT]
Once the access level has been enabled the password can be checked or changed.
From {PASSWORD}{ACCESS 2} :-
DO NOT FORGET TO LOG YOUR NEW PASSWORD
28
DATE SHIPPED
ACCESS 1 1111
ACCESS 2 2222
Once select is pressed the state of the password is shown either enabled or disabled press
[CHANGE] until the desired state is shown.
There are now two options :-
[SELECT] To abort and return to the {ACCESS 2} menu.
[[SELECT]] Used to save the new state.
When {SAVED} is displayed press [SELECT] to return to {ACCESS 2}.
[SELECT]{ENABLED}[SELECT]{2222}
The first character will be flashing, use the change and select keys to enter the password
number you require. When the last character is set the display will flash.
There are now two options :-
[SELECT] Press briefly to abort and return to the {ACCESS 1} menu.
[[SELECT]]
Press and hold to save the new code.
When {SAVED} is displayed press [SELECT] to return to {ACCESS 1}.