Delta Controls 2HTDCAL User Manual

Page 14

{VIEW}

The view menu is not protected by a password, as no changes can be made from within this menu
option. After five minutes it will return to the monitor mode.

Pressing {CHANGE} wil move down through the menu.

At the end of each sub-menu, select {ESCAPE} to return to the higher menu.

{INPUT}

[SELECT]

Enter the input menu

{SENSOR}

[SELECT]

Enter the sensor menu

{SER NO}

[SELECT]

Show the sensor serial number, in decimal

{HILIMIT}

[SELECT]

Show the sensor URL in engineering units

{LOLIMIT}

[SELECT]

Show the sensor LRL in engineering units

{MINSPAN}

[SELECT]

Show the sensor’s minimum available span, If
this is exceeded when using turndowns greater
than 20 to 1 an error will be reported.

{RANGEHI}

[SELECT]

Show, in engineering units, the transmitter URV
corresponding to 20 mA

{RANGELO}

[SELECT]

Show, in engineering units, the sensor LRV
corresponding to 4 mA.

{DAMPING}

[SELECT]

Show the damping value in seconds. This is
applied to the analogue and digital output
signals.

{BURNOUT}

[SELECT]

This shows which direction the analogue output
will go in event of a fatal sensor failure.