CHIEF TS218SU User Manual

Page 9

Installation Instructions

TS218SU

Attach Faceplate to Display Using Interface Brackets

Lay display face down on protective surface.

CAUTION:

Using screws of improper diameter may

damage your display! Proper screws will easily thread into
display mounting holes.

Select screw diameter by examining hardware (A-D) (4mm,
5mm, 6mm or 8mm) and comparing with mounting holes on
display. (See Figure 8)

Select spacers: (See Figure 8)

•

If mounting holes are not recessed and interface
brackets (P and Q) can lay flat against display,
then no spacers are required.

•

If mounting holes are recessed, or if protrusions
prevent brackets (P and Q) from laying flat, then
spacers (E2) must be used.

CAUTION:

Using screws of improper length may damage

your display! Proper screws will have adequate thread
engagement without contacting bottom of display mounting
holes.

Select screw length: (See Figure 8)

•

Using your hand, insert SHORTEST length screw
of selected diameter (A1, B1,C1 or D1) through
universal washer (E1) or M8 washer (E3), bracket
(P or Q), selected spacer (E2, if required), into
display mounting hole. Do NOT thread screw into
hole at this time.

NOTE:

If using M8 button head cap screws (D1-D3), use M8

washers (E3) rather than universal washers (E1).

•

Proper screw length requires base of screw head
to protrude above flat washer a distance equal to
or greater than the screw diameter. If screw
length is inadequate, select longer screw. Select
shortest screw which will protrude the required
distance.

Use selected screws and spacers to connect interface
brackets to back of display. (See Figure 8) or (See Figure 9)
for portrait mounting

Figure 8

Figure 9

(configuration 2 shown)

(A-C) x4 or

(D) x4

(E1) or (E3) x 4

(E2) x 4

(with recessed holes)

(portrait mounting)

(A-C) x4 or

(D) x4

(E1) or (E3) x 4

(E2) x 4

(with recessed holes)