CEMB USA C65 (F) User Manual
Page 9
I 0426 - 8
I 0426 - 9
b
Pos B
Pos A
8
b
GB
GB
5.3 - Presetting of wheel dimensions
5.3.1 - Automatic Presetting
The screen appears upon removing the distance + diameter gauge.
The indication “dimension acquired” is given by the symbol of the correction weight which changes from blue to red.
- Standard wheels: Using the appropriate handgrip, move the end of the gauge against the rim in one of the
positions A/B shown in figure 8:
- Hold the gauge still in position for at least 2 seconds.
N.B. - Always use the round part of the gauge striker surface.
INDICATOR
L.T. function enabled
(see
Buttons Enabled)
INDICATOR: Width
Sonar function
enabled
If the beep signal is enabled (see
ACUSTIC
SIGNAL
)
, successful acquisition of the dimensions
is accompanied by a “beep”.
- Press
6
- In manual mode, preset width
“b”
(see
MANUAL PRESETTING
).
- Normally the “nominal” width is stamped on
the rim; or else measure dimension
“b” with the
calliper gauge (standard accessory).
AUTOMATIC WIDTH MEASUREMENT (OPTIONAL)
Gradually lower the guard after carrying out measurement of distance + diameter in automatic mode.
If the width measured is incorrect (out of range), the following message appears:
“Sonar measure is out of range:”
“F1 = repeat”
“F2 = manual set-up”
Manual