CEMB USA C71_2 SE evo (B) - Manual (Page 11)

11
a
b
b
Use and maintenance manual Rev. 10-2012
ENGLISH
5 Use of the wheel balancer
5.1 PRESETTING OF WHEEL DIMENSIONS
The balancing data is set by means of an “intelligent” au-
tomatic gauge; confi rmation of the measurement and the
position appear on the display. The round part of the gauge
must rest on the rim where the weight will be positioned.
While the gauge is moving the following appears:
when the measurement has been stored:
a) standard weights:
when only one measurement is
made, the machine interprets the presence of a rim with
clip-on weight correction
5.1.1 ET (This function is available only in
the absence of the LA sonar)
Enabling the ET function, after the end of the automatic
distance and diameter measurement, the wheel balancer
suggests the most likely width value for the dimensions just
Use of the wheel balancer
acquired. The outside weight symbol is displayed in
orange to indicate that the user should check it. If necessary,
change the width value by pressing the
buttons, otherwise proceed with normal balancing.
ATTeNZIoNe
The ET function does not work with the adapters
If the ET function is disabled, the width value (b) must be
set with the buttons.
The correct measurement is that which can be measured
with the compass gauge provided.
b) adhesive weights:
make two successive measurements
on two correction planes inside the rim.
The balancing machine automatically interprets that the
correction will be made with adhesive weights and the
following appears:
For a different combination of the type or position of the
weights on the rim, use the buttons.
5.1.2 AUTOMATIC WIDTH (OPTION)
At the end of the automatic measurement of the distance
and diameter the following appears:
For large wheels (e.g. off-road vehicles, light trucks or wheels
protruding far out from the rim) press the button to
switch from:
N.T. = NORMAL TYRE
L.T. = LIGHT TRUCK