CEMB USA C218 User Manual - Manual (Page 7)

7
Use and maintenance manual Rev. 04-2011
ENGLISH
Starting
3. Starting
WARNING
B EFORE SWITCHING ON THE MACHINE , MAKE SURE THAT ALL THE
CONNECTIONS DESCRIBED IN THE INSTALLATION CHAPTER
HAVE BEEN MADE CORRECTLY .
T HE FOLLOWING OPERATIONS INVOLVE A POTENTIAL RISK FOR
THE OPERATOR , GIVEN THE PRESENCE OF VOLTAGE ON THE
EQUIPMENT . T HE P ERSONAL P ROTECTIVE E QUIPMENT DESCRIBED
IN THE INSTALLATION MANUAL MUST BE WORN AND WORK
MUST BE DONE WITH DUE CARE AND ATTENTION .
O PERATIONS MAY ONLY BE PERFORMED BY A
SPECIALISED TECHNICIAN .
Before powering the machine, carry out the following
checks:
1. check that the balancing machine touches the floor
at the three support points;
2. make sure that all the parts of the balancer are cor
rectly connected and fixed;
3. make sure that the parameters (voltage and frequency)
of the mains power supply are compatible with those
indicated on the rating plate of the balancer;
4. make sure the power cable is correctly connected;
5. make sure the machine shaft and flange hole are
clean.
CAUTION
A NY TRACES OF DIRT MAY AFFECT BALANCING ACCURACY .
6. To switch on the balancer press the switch on the
left-hand side of the machine
7. This pedal controls ascent and descent of the lift
integrated in the machine. The carriage is manually
driven.
8. Position the wheel on the terminal with the inner part
facing the balancer;
9. Firmly attach the wheel to the balancer shaft using
the lock nut.
10. At this point, you can read the tyre measurements
and perform balancing.