J&M GC-24T Assembly - Manual (Page 3)

GC24
t
-1 G
rain
C
art
a
ssembly
-3-
STEP - 4
STEP - 3
Set the axle weldment up on blocks. Insert four digistar weigh bars. Use 1” x 6” bolts to attach weigh
bars to axle weldment. Make sure that the arrows on all of the weigh bars are pointing up. Attach
the scale bar mounts to the weigh bars using 1” x 5” bolts. Be sure to use correct scale bar mounts in
correct positions. Use (8) 1” center locking nuts on the bolts.
1”x 5” Bolt
1”x 5” Bolt 1”x 6” Bolt
1” Center Locking Nut
Left Scale Bar Mount
Right Scale Bar Mount
Axle Weldment
M24 Lock Nut
Set the main frame onto the scale axle using an overhead hoist. Line up the holes and bolt together using
(12) M24 x 75 MM hex cap screw bolts and (12) M24 nylon locking hex nuts. Make sure scale wires are
not in a position where they will be cut or smashed.
1” Center Locking Nut
m24
x
75 mm B
olt
-Scale Option-
-Scale Option-
Weigh Bar (short side to
the inside)