J&M GC-24T Assembly - Manual (Page 19)

GC24
t
-1 G
rain
C
art
a
ssembly
-19-
STEP - 36
STEP - 35
Using an overhead hoist, lift the bottom tube assembly using the lifting hook holes. This should help
set the appropriate angle for laying the assembly into the tank.
Using an overhead hoist, lift the bottom tube assembly into the front left corner of the grain
cart. Lower the bottom tube assembly until the two corners that are circled in the figure to the
right to go below the tank assembly. Then raise the lower auger back up so that the two circled
corners can be bolted to the tank. Attach using (25) M10 x 25 MM serrated hex head bolts and
(25) M10 serrated hex nuts. Use a drift pin as needed to help line up the holes accordingly.
The bottom tube needs to rest on
the outside of the corner piece that
is attached to the rails.