Castle TSM-21 Diagnostic Manual User Manual
Castle inc, Diagnostic manual, Tsm-21
Table of contents
Document Outline
- 1 Introduction
- 2 Dry Cycle Testing 21.95
- 3 Definitions
- 4 Diagnostic Descriptions
- 5 Procedures
- 5.1 Clamp Foot Pad or Cylinder Replacement 21.01
- 5.2 Unclogging the Clamp Solenoid 21.10
- 5.3 Clamp Solenoid Check 21.11
- 5.4 Clamp Cylinder Check 21.12
- 5.5 Pilot Valve, Clamp Exhaust Check 21.13
- 5.6 Pilot Valve Check and Replacement 21.14
- 5.7 Router Motor Operation 21.20
- 5.8 Adjusting the Web, Router Stop Plate 21.21
- 5.9 Router Stop Switch (NC) 21.22
- 5.10 Unclogging the Router Solenoid 21.30
- 5.11 Router Check Solenoid 21.31
- 5.12 Router Feed Rate Adjustment 21.32
- 5.13 Drill Motor Operation 21.40
- 5.14 Drill Settings and Bit Depth 21.41
- 5.15 Drill Single Coil Bar Spring 21.42
- 5.16 Drill Stop Switch (NC) 21.43
- 5.17 Unclogging the Drill Solenoid 21.50
- 5.18 Drill Solenoid Check 21.51
- 5.19 Drive Cylinder Check 21.60
- 5.20 Drive Cylinder SQE (Super Quick Exhaust) Valve 21.61
- 5.21 Pilot Hole Alignment 21.72
- 5.22 Foot Switch (NO) 21.80
- 5.23 Resetting the Machine 21.81
- 5.24 Safety Switch/Safety Buttons (NO) 21.82
- 5.25 Tooling Check and Replacement 21.83
- 5.26 Air Pressure Regulator Setting 21.90
- 5.27 Replacing Solenoid Valves 21.91
- 5.28 Attaching Air Supply 21.92
- 6 Appendix A – Machine Safety 21.80
- 7 Appendix B – Wiring Diagram 21.84
- 8 Appendix C – Control Box Works 21.93
- 9 Appendix D – Solenoid, Pneumatic Diagram 21.94
- 10 Appendix E – Control Box Works 21.93
- 11 Appendix F – Solenoid, Pneumatic Diagram 21.94
- 12 Appendix G – Index