Castle TSM-21 Diagnostic Manual - Manual (Page 32)

5.12.1 TO RESET THE ROUTER FEED RATE:
1.
Locate the Feed Rate knob on the left of the case and fully loosen the Jamb Nut. See
Fig 14
.
FASTER
Knob and Jamb Nut
Router Feed Rate
SLOWER
Fig 14
2. Rotate the Feed Rate knob fully clockwise until it stops.
3.
Rotate the Feed Rate knob 2 full revolutions counter-clockwise.
4.
This setting is typical for hard woods.
5.
Adjust the Feed Rate to your material by ½ or ¼ turn at a time to obtain a clean, smooth
pocket.
6. Counter-clockwise increases the Router Feed Rate, Clockwise decreases the Router
Feed Rate.
7.
Tighten the Jamb Nut after adjustments are finalized.
Note: If the Router comes up with the Feed rate knob turned fully clockwise, the Feed rate
valve should be replaced.
Castle Inc TSM-21 Diagnostic Manual v2 Page 32 of 63