Castle TSM-21 Diagnostic Manual - Manual (Page 31)

Castle Inc TSM-21 Diagnostic Manual v2 Page 31 of 63
Pilot Valve, up to
sn:61076
Clamp Exhaust
Clamp Solenoid
Router Solenoid
Fig 13
3. Attach the air supply to the machine and see if the drill now extends instead of the router.
4.
If it does, the Router Solenoid has stuck open.
5. Swap the air lines back again.
6.
Perform procedure 21.30 “Unclogging the Router Solenoid”.
5.12 Router Feed Rate Adjustment 21.32
The Router Feed Rate is adjustable to accommodate varying materials and/or bit types. If the
Router Feed Rate is too fast, stock slippage, poor pocket quality, or dulled tooling may result. If
the Router Feed Rate is too slow pocket burning and premature wear of the tooling may result.
As a rule of thumb – the harder the material, the slower the feed rate of the Router.
Note: If the Pressure Regulator has been adjusted, readjust the Router Feed Rate (if
necessary) AFTER the Pressure Regulator setting has been finalized.
Air IN lines
Air OUT lines
Drill Solenoid
Router Feed Rate Knob
Regulator Knob