Castle TSM-35 Operator Manual - Manual (Page 4)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 4 of 33
1 Introduction
Thank you for making the Castle TSM-35 the latest addition to your shop. Since 1985 our goal
has been to manufacture and develop machines that make cabinetmaking and casework easier,
faster and more profitable for the woodworker. This machine represents our commitment to your
productivity. Castle machines are made in Petaluma, California and are manufactured to the
highest standards using local vendors wherever possible.
This instruction manual is intended for use by anyone setting up or servicing this machine. It
should be kept available for immediate reference so that all operations can be performed with
maximum efficiency and safety.
Your TSM-35 will pocket any material you would normally rout. It is designed for material from 1
½” to ½”. Use of materials thinner than ½” is not recommended. Every TSM-35 machine is
factory adjusted and tested with sample material. If you should find a small amount of saw dust
in the bottom of your TSM-35, please don’t be alarmed.
Note: Do not attempt to perform maintenance or operate this machine until you have read
and understand the information contained in this manual.