Castle TSM-35 Operator Manual - Manual (Page 30)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 30 of 33
Note: The model TSM-35 uses bearings that are pre-lubricated. No bearing lubrication is
necessary. However, an automatic Lubricator is attached to the Air Regulator. Air
tool oil must be kept in the Lubricator at all times.

The Lubricator should be set so that a slight deposit of oil and dust occurs at the drill
motor exhaust. The exhaust is located in front of the drill motor behind the drill motor
collet.

The oil / dust deposit should not occur until the machine has been run for at least 4
hours. If after 4 hours of use you don’t see this deposit, adjust the Lubricator knob on
the front of your machine counter clockwise about ¼ turn and run the machine again.
Keep adjusting until the deposit begins to show.
7.2 Motors and Bits
Because the motors are enclosed in the machine, it is important that the maintenance guidelines
provided in the manufacturer’s instruction manual be strictly observed.

Periodically during operation, blow out the air passages on both motors with 30 PSI
compressed air.
Caution: Always wear safety goggles when using compressed air.

To prolong motor life, and avoid costly downtime, dust collection is recommended. A
port has been provided on the rear of the machine for this purpose.

To ensure safe and effective operation, make certain that there is at least 80 PSI air
pressure to the machine. Check cycle time of machine for proper duration. A typical
cycle under normal conditions will last from 1
1
/
2
to 2 seconds. A cycle significantly
longer than this may lead to excessive bit wear.

Your TSM-35 comes equipped with Castle’s premium tooling including the 3/8” four flute
solid carbide router bit; Castle Part #B00338. The solid carbide bit is universally useful in
panel, melamine, mdf as well as for use in solid wood. Your machine also comes with
our TiN coated premium drill bit; Castle Part #B02964.

For use in solid woods such as maple, oak, ash or alder we recommend the three flute
HSS cobalt bit; Castle Part # B00438 .