Castle TSM-35 Operator Manual - Manual (Page 21)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 21 of 33
5.11 Router Stop Switch
Much like the Drill Stop Switch, the Router Carriage also uses a magnetic reed switch to tell your
TSM-35 when it has reached the end of its stroke for the router part of the cycle. In the event
that this switch comes out of adjustment, your router will come up in the pocket and either return
before reaching the end of the stroke, or the router bit will not return at all after cutting the
pocket. The Sick switch is equipped with an orange LED when active.
Fig 11
1. Turn off Air and Electrical power to machine and raise the Case Top to its fully
opened position.
2. Under the drill you will find two cylinders. The cylinder on the right is the cylinder which
drives the Router Carriage.
3. On the Router Carriage Cylinder, there is a switch with a tensioning screw. Use a Phil-
lips screw driver to loosen the screw so the switch can move freely.
4. Open the door on the Control Box after you are sure that electrical power and air have
been shut off to the machine.
5. Use a continuity tester and touch it to pins 7 and 8 on the Control Board Terminal Strip.
You may read a few kilo Ohms of resistance.