Castle TSM-35 Operator Manual - Manual (Page 15)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 15 of 33
the pilot bit is the center of the hole provided in the case top. The following are instructions for
adjusting where the centered position is.
Fig 5
1. Turn off Air and Electrical power to the machine and raise Case Top to its fully
opened position.
2. There are two Jacking Screws on each side of the machine. The bottom Jacking Screws
are for the drill carriage.
3. Use a
7
/
16
” wrench to loosen the ¼ -20 Nylock nut on each side of the machine.
4. Once the Nylock nuts are loose, use a
1
/
8
” Allen wrench to move the carriage left or right.
Loosen the left side and tighten the right to move the carriage to the left. Loosen the right
side and tighten the left to move the carriage to the right.
5. Once you have adjusted the Jacking Screws, apply air and power to the machine and cut
a test pocket.
6. If the pilot hole is in the appropriate position for the particular application, use a
1
/
8
” Allen
wrench to secure each Jacking Screw while tightening the ¼-20 Nylock nut with a
7
/
16
”
wrench on both sides of the machine.