Castle TSM-35 Operator Manual - Manual (Page 24)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 24 of 33
Drill Feed Speed:
The Drill Feed Speed is the flow control valve located under the
Case Top, near the back of the machine, left of center and can be
seen through an access hole in the Safety Pallet. The Drill Feed
Speed controls how fast the drill comes forward into the material.
Web Adjustment Plate:
The Web Adjustment Plate is under the Case Top, mounted at the
rear of the white Safety Pallet, just to the right of center. The plate
can be identified by the two bolt heads sitting on top of the plate.
The position of the plate determines the size of the web.
FRL (Filter, Regulator, Lubricator):
The FRL or Filter, Regulator, Lubricator, is located on the front of
the machine to the right of the Control Box. The FRL regulates and
filters the air going into the machine. It also sends oil to the Sioux
air drill.
Drain Cock:
Located on the bottom of the Air Reservoir, it can be accessed
through the front door of the machine. The Drain Cock allows you
to keep the reservoir and the drill free of excess condensation.
Inline Filter:
The Inline Filter is located behind the door on the case front. It can
be seen hanging down at the top of the door opening. The Inline
Filter cleans the air before it goes into the machine’s valves.