MoTeC CDL3 - Manual (Page 44)

44 Configuration
Numeric Displays
The three numeric displays–left, right and top right–can be programmed to
display any value, which may be different for each of the display modes
(Warm-up, Practice and Race).
Each of the three numeric displays has a different number of digits and is
therefore suited to displaying different values. For example the top right
display can only show values up to a maximum of 199 and is therefore not
suitable for displaying Lap Times, but is suitable for values such as Lap
Number, Fuel Remaining or Engine Temperature.
The numeric displays can show any channel value plus up to two override
values. Override values show each time their value is updated. This is useful
for values that are updated periodically. The override values are shown for a
programmable period of time. For example, a numeric display could normally
show the Running Lap Time (which is continuously updating), then be
overwritten by the Lap Time for 10 seconds each time the Lap Time is
updated.
Enunciators for common displayed values are provided above the numeric
displays (e.g. ET for Engine Temperature, OP for Oil Pressure).
Centre Numeric Display