I-View SDCI-220 Indoor Speed dome - Manual (Page 12)

12
of “Zero Illuminance”, is automatically switched without control, and
then above “Zero Illuminance” is invalid.
4. Notes to “Patrol” Function of the dome camera:
① Automatically scan from no.1 to no.16 preset points one by one.
If some points do not have been preset or are cleared out after
presetting, they will be bypassed when patrol is carrying out.
② The dwelling time between to preset points is 4 seconds.
③ The “Patrol” function of the dome camera can be carried out by
presetting no.51 position.
1.
Notes to “Scan (auto pan)” Function of the dome camera:
① The dome camera makes automatic scan between two specified
positions.
② The speeds of scan are divided into three levels. You can call no.
51, 52 and 53 preset position to start scan at speed of 1.5°/ sec,
5°/ sec and 10°/ sec separately.
③ The dwelling time between the “Start Point” and “End Point” of
scan is 3 seconds.
2.
All notes mentioned above are supplementary descriptions under high
speed. All original operations of the control system are unchanged.
Settings of Communication Baud Rate of the dome Camera.
Dip
switch
Baud Rate
1 2 3 4 5 6
2400 bps - - - - OFF OFF
4800 bps - - - - ON OFF
9600 bps - - - - OFF ON
19200 bps - - - - ON ON