AUMA Electric multi-turn actuators SA 07.1 - 48.1_SAR 07.1 - 30.1 NORM - Manual (Page 30)

30
Multi-turn actuators SA 07.1 – SA 48.1 / SAR 07.1 – SAR 30.1
AUMA NORM
Operation instructions
Notes:
When placing orders for spare parts, it is essential to mention type of actuator and our commission number (refer to
actuator name plate). Delivered spare parts may slightly vary from the representation in these instructions.
● not available for all output speeds
* not included in basic equipment
No. Type Designation
1.026 E Quad ring / radial seal
1.038 E O-ring
1.1 B Housing assly.
1.17 B Torque lever assly.
1.19 B Crown wheel assly.
1.22 B Drive pinion II for torque switching assly.
1.23 B Drive wheel for limit switching assly.
1.24 B
Intermediate wheel for limit switching
assly.
1.25 E Locking plate
1.27 E Screw plug
1.28 E Bearing bush
2.58 B Motor
2.59
●
B Planetary gear assly. for motor drive
3 B Drive shaft assly.
3.05 E Dowel pin
3.11 B Pull rod assly.
3.6 B Worm wheel assly.
3.7 E Motor coupling
3.8 B Manual drive coupling assly.
4.2 B Flange, bottom assly.
4.3 B Hollow shaft assly.
5 B Planetary gear assly. for manual drive
5.1 E Mounting flange
5.2 B Hand wheel shaft assly.
6 B Swing lever assly
7.012 E Notched pin
7.14 E Change-over lever
7.50 B Handwheel with ball handle assly.
8.36 B
Control unit assly. (but without torque
head, without switches)
8.37 B Switch compartment cover
9.33 B Terminals for motor connection
9.51 B Protective earth connection
9.55 B
Cover for motor connection compartment
assly.
50.0 B Plug cover assly.
51.0 B Socket carrier assly. (with sockets)
52.0 B Pin carrier (without pins)
53.0 B Socket for control
No. Type Designation
54.0 B Socket for motor
55.0 B Socket for protective earth
56.0 B Pin for control
57.0 B Pin for motor
58.0 B Wire for protective earth
61.0 B Torque switching head
80.0 * B
Output drive form A assly.
(without thread in stem nut)
80.001* S Thrust bearing set
80.3 * E Stem nut form A (without thread)
85.0 * B Output drive form B3 assly.
85.001* E Snap ring
100 B
Switch for limit/ torque switching
(including pins at wires)
105 B
Blinker transmitter including pins at wires
(without impulse disc and insulation plate)
106.0 B Stud bolts for switches
107 E Spacer
151.0 B Heater
152.1 * B Potentiometer (without slip clutch)
152.2 * B Slip clutch for potentiometer
153.0 * B RWG assly.
153.1 * B Potentiometer for RWG (without slip clutch)
153.2 * B Slip clutch for RWG
153.3 * B Printed board for RWG
155.0 * B Reduction gearing
156.0 * B Mechanical position indicator
160.1 * E Protection tube (without cap)
160.2 * E Cap
S1 S Seal kit (small)
S2 S Seal kit (large)