Dcs 20, Mxx), Dcs series – Atec Sorensen-DCS Series User Manual
Page 7: 1–3 kw, Series voltage, Current, Options
858.458.0223
Model Number Description
DCS 20
Series
Voltage
50E
Current
(MXX)
Options
Software
IVI-Com and Labview drivers available for free download at http://www.elgar.com/products/DCS/DCS_Downloads.htm
DCS Series
Options and Accessories
M1
Factory configured for 115 VAC input (1 kW and 1.2 kW units only)
M9C
Internal IEEE-488/RS-232 Interface (can only support 12-bit slaves)
M13
Locking shafts (front panel potentiometers)
M32
Master/slave paralleling cable configured for two units
M33
Replace input connector with terminal block (3 kW only)
M51A
Isolated analog programming control of V/I/OVP and isolated V/I monitor outputs up to 500V relative to the supply’s return line.
This isolation allows users to control power supplies not connected to a common ground. In addition, in systems with high
ambient noise or with large ground loop currents the control ground can be isolated from the power ground eliminating problems.
M85
12-bit slave interface option for use with M9 or M130 master (3 ft. control cable included)
M102
Front panel binding posts for 1 kW or 1.2 kW, Models ≤30A, ≤100V.
Not compatible with M9C, M85, M130, M131, M133, M135, M136
M130
LXI™compliant 10/100 Base T Ethernet remote control master interface; includes web server for direct control of
power supply via web browser (MS Internet Explorer 6.0 or later)
M131
16-bit slave interface option for use with a M130 master (3 ft. control cable included)
M133
Output disconnect and polarity reversal relays controlled via SCPI commands. Limited to 1kW or 1.2 kW, ≤100V, ≤60A
M135
M130 & M133 combination. Limited to 1kW or 1.2 kW, ≤100V, ≤60A
M136
M131 & M133 combination. Limited to 1kW or 1.2 kW, ≤100V, ≤60A
105-300-26
Rack slide kit (3 kW only)
1–3 kW
© 2009 AMETEK Programmable Power All rights reserved. AMETEK Programmable Power is the trademark of AMETEK Inc., registered in the U.S. and other countries.
Elgar, Sorensen, California Instruments, and Power Ten are trademarks of AMETEK Inc., registered in the U.S.
49