Atec California-Instruments-6000L - Manual

AC Power Systems
L-Series
Full Capability
AC Sources
for Product Test
Now you can test any product
that operates from AC power with
the most compact, versatile
power source in the test industry.
The L-Series’ small size provides
more power per inch than most
other AC supplies. Highly effi-
cient, these products dissipate
less heat than previous genera-
tion systems and allow up to an
additional 10 % output power.
With a programmable controller,
L-Series models provide the most
comprehensive set of program-
mable functions in the industry.
Automatic remote calibration and
comprehensive self-tests simplify
maintainability.
All L Series units are com-
pletely self-contained. Control is
through an embedded oscillator,
factory configured to your specific
requirements. Output parameters
are controlled via the front panel
or the IEEE-488 bus. Bus pro-
gramming, standard with -P,
-PT and HGA controllers, allows
programming and measure-
ment function readback com-
patible with a number of other
standards including VXI, MXI
and RS232 via recommended
translators. To simplify pro-
gramming, the standard unit
supports both Abbreviated Plain
English programming and an
ATLAS-based control language.
For avionics applications, any
3-phase model can be config-
ured with 26 V and 5 V auxiliary
outputs. (AX option)
The L Series is ideal for ap-
plications where small size, low
heat dissipation and light weight
are important. These include
DC power supply testing, pro-
duction test, quality assurance
verification, engineering and
ATE.
Test All Products Operating
from AC Power
Controller Choices:
n n Simulate Non-Standard AC
Line Conditions
Line disturbance simulation
n n Monitor Load Parameters
Without Additional Instru-
mentation
Full measurement capability
on programmable controllers
High Frequency PWM Design
n n Rack Space Savings up
to 50 %
Small front panel size and
weight for precision power
n n High Efficiency
Generates less heat and
consumes less input
power
n n Voltage ranges up to 400 V
RMS , L-N
Standard 135/270 V or optional
ranges to 400 V
n n Single- and Three Phase Models
3 kVA to 30 kVA products re-
configurable for single- or three-phase
operation (MODE option)
n n High Peak Current Capability
Up to 9:1 crest factor for driving high
peak current loads
n n High Frequency Range
Capable of output frequencies up to
5000 Hz on some
models