Atec Chroma-61600 Series - Manual

Programmable
AC Power Source
Chroma Programmable AC Power Source
61600 series delivers pure, instrument grade
AC power at very low cost. The 61600 series
supplies the output voltage from 0 to 300VAC,
and frequency from 15 to 1000Hz. It is
suitable for commercial, avionics, and military
applications from bench-top testing to mass
production.
The 61600 series generates very clean
AC output with distortion less than 0.3%
at 50/60Hz. With the state-of-the-art PWM
technology and power factor correction circuit,
the 61600 series yields higher efficiency and
delivers more output power. The 61600 series
is capable of delivering up to 6 times of peak
current compared to its maximum rated current
that makes it ideal for inrush current test.
The AC+DC modes extend the applications not
only pure AC voltage but also DC component
for testing DC offset in laboratory. Users also
can use an optional DC noise filter to get low
noise and good stability DC voltage for testing.
Applying the advanced DSP technology, the
61600 series is able to provide precision and
high speed measurements such as RMS
voltage, RMS current, true power, frequency,
power factor, and current crest factor.
The 61600 series also provides an external
analog input to amplify the analog signal from
arbitrary signal generator. Thus, it is capable
of simulating the unique waveform which
observed in the field. Users also can control the
amplitude of output voltage by a DC level. It is
suitable to integrate Chroma AC source 61600
series into users' system.
For convenience sake, the 61600 series offers
versatile front panel operations with LCD
display and rotary knob. Users may also control
the 61600 series AC source remotely via
GPIB, RS232C or APG (Analog Programming)
interface. Users can find Labview driver in NI's
web site for programming.
The power-on self-diagnosis routine along with
the full protections against OPP, OCP, OVP
and OTP ensure the quality and reliability for
the most demanding engineering tests and ATS
applications.
PROGRAMMABLE AC POWER SOURCE
MODEL 61600 SERIES
MODEL 61600 SERIES
RS-232C GPIB APG
Key Features:
■ Output Rating :
Power: 500VA (61601), 1000VA (61602)
1500VA (61603), 2000VA (61604)
4000VA (61605)
Voltage range: 0-150V/0-300V/Auto
■ Frequency : 15Hz - 1000Hz
■ Compact size and weight attributable to
advance PWM technology
■
Built-in PFC, provide input power factor
over 0.98 (full load)
■
AC+DC output mode for voltage DC offset
simulation
■
Programmable slew rate setting for
changing voltage and frequency
■
Programmable voltage, current limit
■ One-key recall for 9 different voltage and
frequency
■
Low output impedance for testing IEC
61000-3-2 (61605)
■
Comprehensive measurement capability, V,
Irms, Ipk, Inrush, P, Q, S, PF, CF of current
and etc.
■
High output current crest factor, ideal for
inrush current testing
■
Turn on, turn off phase angle control
■ TTL signal which indicates ON/OFF
■ 3 units combined to 3-phase power output
■ Easy-use software for operation and
ON/OFF test
■
Optional analog programming interface
■ Optional GPIB and RS-232C interface
■ Full protection: OP,OC,OV and OT
protection