Atec TTC-6000 - Manual (Page 4)

3
Packet Network Testing
Perform analysis of your circuits and equipment
during deployment and provisioning of your network by
generating frame relay and ATM traffic. Perform analysis
on lost frames or cells by generating fixed or variable
loads of traffic over multiple virtual channels to verify the
service that your customers demand. The capability to
test the physical layer and data link layer in a single
platform provides the information to troubleshoot the
most complex problems.
In-Service monitoring
Monitor live data at various access locations, from
resistor-isolated DSX monitor points to a bridge on a
four-wire access point, without disturbing revenue-
generating traffic. Ideal for routine maintenance, the
FIREBERD 6000 offers a variety of in-service measure-
ments, including bipolar violations, timing and level
analysis, frame errors, and CRC errors.
T1/FT1
X.21
HSSI
V.35
RS-449
EIA-530
MIL 188-114
FIREBERD
RS-232C
RS-232D
MIL-188C
T1/FT1
V.35
RS-449
EIA-530
RS-232
V.35
RS-449
EIA-530
WAN Protocol
DDS Local Loop
T1/FT1/2M/
Nx64/DS-3
DDS DS0A/B
T1/FT1/2M/DS-3
MUX or
Channel Bank
DTE
Smart
Jack
OCU-DP
Channel Bank
T1 CSU
or
FT1 DSU/CSU
T1/FT1
T1/FT1/2M
Nx64/T3
DDS DS0A/B
Channel Bank MON
DSX-1
T1/E1
Telco/Carrier Central Office or
Large Network Node
CPE & Local Loop
MON MON
DSX-1
MON
DS3
MUX
DDS
DSU/CSU
CSU
or NTU
T-Carrier or
CCITT-standard
Network
The FIREBERD in the
digital network
End-To-End Testing
Quickly isolate any problem to a specific direction
by analyzing the performance of an entire digital link in
both directions. Full-duplex end-to-end testing also serves
as an excellent analysis of all circuits and equipment
within your network.
Loopback Testing
Enjoy the convenience of using a single
FIREBERD 6000 to perform out-of-service testing.
Loopback testing is ideal as a quick check of circuit
performance or when isolating faulty equipment. The
FIREBERD 6000 supports all standard TI, E1, DDS, and
data communications loopbacks.