Atec TTC-6000 - Manual (Page 10)

9
DDS Testing
For testing at a D4 channel bank, the DDS DS0A/B Module enables the FIREBERD 6000 to analyze DDS subrate
circuits, with DS0A, DS0B, and clear channel compatibility for all data rates. The module provides complete loopback
support, which allows a DDS circuit to be completely sectionalized in either direction using alternating and latching
loopbacks. For testing DDS four-wire facilities to the customer premises, the DDS Local Loop Module emulates a DSU/
CSU at all data rates, including 64 kb/s clear channel service. Unique stress and signal capabilities provide quick detection of
marginal circuits and equipment. You can perform frame relay testing from any DDS access point—both the DDS DS0A/B
Module and the DDS Local Loop Module are completely compatible with the FIREBERD 6000’s Frame Relay Option.
Highlights
• Perform comprehensive BERT
• Test and maintain the digital cards of a D4 channel bank such as an OCU-DP, DSU-DP, and DS0-DP
• Test the DSU/CSU or four-wire facility of a DDS circuit at the customer premises
• Test the entire range of DDS service from 2.4 kb/s to 64 kb/s, with or without secondary channel
• Sectionalize circuit problems using comprehensive loop-code generation and auto response
• Detect excessive signal attenuation and sealing current problems on the four-wire local loop
• Send or report network condition codes with byte encoder and result display
TIMS-45 Analog Lid Option
The TIMS-45 Option enables you to perform both VF and wideband TIMS tests on analog and digital transmission
lines with your FIREBERD 6000. New filters and a frequency range between 50 Hz and 300 kHz enable you to test high-
bit-rate digital subscriber line (HDSL), DDS, and ISDN circuits. The TIMS-45 integrates into the lid of the FIREBERD 6000
so you can use it anywhere. The large screen enables you to view all test setups and results at a glance. You can print test results
to any printer with the RS-232 port. With the external power adapter, you can even use the lid as a stand-alone tester.
Software
Distributed Test Manager (DTM)
The DTM Option enables you to perform remote testing from your PC, expanding the field service
capabilities of the FIREBERD 6000 into network control centers. Compatible with all interface modules
and mainframe options, Windows
® -based DTM software makes your PC a cost-effective platform for wide
area transmission tests and extends the reach of your field technicians.
Dynamic Script Generator (DSG)
Developed to operate on the user-friendly Windows ® 95 and Windows ® NT platforms, the
Dynamic Script Generator allows you to generate and run multiple scripts in succession on your
PC to control and gather information from your FIREBERD 6000.
Highlights
• Supports testing of T1/FT1, 2M/Nx64, V.35/306, RS-449, X.21, EIA-530 and DDS
• Enables rapid test setup and execution with less work for the technician
• Allows test scripts to be created and shared among technicians
• Permits information retrieval and analysis on your PC