Atec TTC-6000 - Manual (Page 11)

10 10
IEEE-488.2 Remote Control Option
The FIREBERD IEEE-488.2 Remote Control Option gives you the ability to control your FIREBERD 6000 via
computer for automated testing. Ideal for the manufacturing environment, the option lets you control as many as 15
devices with a single controller.
LabVIEW ® Drivers
LabVIEW ® drivers available free from National Instruments ® Corporation enable you to communicate with your
FIREBERD 6000 through the IEEE-488 (GPIB) interface. Using LabVIEW with your computer allows you to send and
receive information from a variety of test instruments, including voltmeters and oscilloscopes, and display the results on
your computer. And you can speed up your automated testing using predefined test scripts—the graphical interface
makes programming simple.
ISU 6000-4 and ISU 6000-8 Interface Switching Units
ISUs offer maximum convenience when using more than two
interfaces by enabling you to switch among up to eight different
interface modules. Select these interfaces from the FIREBERD
6000’s front panel or under remote control for added versa-
tility. ISUs can be rack-mounted in a standard 19" rack.
Rack Mounts
A variety of sturdy rack mounts are available for both
plastic case and metal case FIREBERD 6000 mainframes and printers, standard at 19". A rack mount extension kit
expands available space to 23".
Printers
• PR-45A Lid Printer
The PR-45A Lid Printer is a thermal, dot matrix printer that mounts in the lid of the
FIREBERD 6000A with a spring-loaded hinge and receives power from the mainframe. The PR-45A
features alphanumeric and graphical printout capability.
• PR-35 Rack Mount Printer
The PR-35 is a rack mountable printer with all of the features of the PR-45A. It can be rack
mounted in a standard 19" rack or, using extenders, installed in a 23" rack.
• PR-2000A Thermal Printer (MC-6000 Rackmount Only)
The PR-2000A Thermal Printer is an alphanumeric, non-impact thermal printer that prints the
full ASCII character set with up to 20 characters per line. This printer may be rack mounted
along with the FIREBERD 6000 in the MC-6000 Rack Mount unit. An RS-232 cable is included,
to allow direct connection to the FIREBERD 6000’s built-in RS-232 interface.