Atec LeCroy-WAVEPRO-950-960 - Manual

WavePro Oscilloscopes
Specifications
Vertical System WavePro 960
DISCONTINUED
WavePro 950
DISCONTINUED
WavePro 940
DISCONTINUED
Input Channels
4
4
4
Analog Bandwidth @ 50
Ohms (-3 dB) 2 GHz* 1 GHz 500 MHz
Bandwidth Limiters 20 MHz, 200 MHz
Input Impedance 50 Ohms ± 1.5%; 10 MOhms // 11 pF typical (using PP005 probe)
Input Coupling 1 MOhms : AC, DC, GND; 50 Ohms : DC, GND
Maximum Input 50 Ohms : 5 Vrms; 1 MOhms : 100 Vmax (peak AC =5 kHz + DC)
Vertical Resolution 8 bits; up to 11 bits with enhanced resolution (ERES)
Sensitivity 50 Ohms : 1 mV – 1 V/div fully variable ; 1 MOhms : 1 mV – 2 V/div fully variable
DC Accuracy ± 2.0% full scale + 1.5% offset value @ gain > 10 mV
Offset Accuracy ± (1.5% + 0.5% of full scale + 1 mV)
Offset Range 50 Ohms or 1 MOhms : 1 mV – 4.99 mV/div: ±400 mV
50 Ohms : 5 mV – 99 mV/div: ±1 V; 0.1 V – 1 V/div: ±10 V
1 MOhms: 5 mV – 100 mV/div: ±1 V; 101 mV – 2 V/div: ±20 V
Isolation — Channel-to-
Channel > 250:1 at same V/div settings
Timebase System
Timebases Main and up to four independent zoom traces simultaneously
Ranges 200 ps/div – 1000 s/div
Clock Accuracy =10 ppm
Interpolator Resolution 5 ps
External Clock Frequency 500 MHz maximum, 50 Ohms, or 1 MOhms impedance
Roll Mode – Operating Range time/div 500 ms – 1000 s/div or sample rate < 100 kS/s max
External Reference 10 MHz timebase reference clock available with input on rear panel
External Timebase Clock 500 MHz maximum external sample clock input on front panel EXT BNC
Acquisition System
Single-Shot Sample Rate
1 Channel Max. 16 GS/s 16 GS/s 8 GS/s
2 Channels Max. 8 GS/s 8 GS/s 8 GS/s
3 – 4 Channels Max. 4 GS/s 4 GS/s 4 GS/s