Atec Micronics-PF330 - Manual (Page 7)

Portaflow 330 Technical Datasheet
Portaflow 330 Technical Datasheet 7
(Issue 2.1)
Technical data
Analogue output: Pulse output:
Range – 4–20mA
0–20mA
0–16mA Output type – One open collector opto-isolated digital
output
Resolution – 0.1% of full scale Pulse repetition – Up to 500 pulses/sec (depending on
pulse width)
Alarm current – Adjustable between 0–26mA Pulse width – 500ms for 1pulse/s
5ms for 100 pulses/s
Isolation – 1500V Opto-isolated Max current – 150mA
Maximum load – 620 Ohms
General specification:
DSP measurement technique – The PF330 uses ‘transit time’ measurement with a sampling resolution of 50 pico-
second, with a continuous signal level indication to the display
Flow velocity range (bi-directional) – • Minimum velocity 0.1m/s
• Max velocity 20m/s
Flow measurement accuracy – • ±0.5% to ±2% of flow reading for flow rate >0.2m/s and Pipe ID >75mm
• ±3% of flow reading for flow rate >0.2m/s and Pipe ID in range 13mm - 75mm
• ±6% of flow reading for flow rate < 0.2m/s
•
Flow velocity corrected for Reynolds number over entire velocity range
Repeatability – • ±0.5% of measured value or ±0.02m/s whichever is the greater
Response time – • < 500ms depending on pipe diameter
Selectable flow units – • VELOCITY: m/sec, ft/sec
• VOLUME: l/s, l/min, l/h, gal/min, gal/h, USgals/min, USgals/h, Barrel/h,
Barrel/day, m³/s, m³/min, m³/h
Selectable volume units – • l, gal, USgals, Barrel, m³
Total volume – • 12 Digits - forward and reverse
Display languages – The following operator languages can be selected from the PF330 set-up menu
• English
• French
• German
• Swedish • Italian
• Spanish
• Portuguese • Russian
• Norwegian
• Dutch