Atec JDSU-ANT-5 User Manual

Page 12

ANT-5 SDH ACCESS TESTER

Remote Control
BN4565/93.61

Enables the remote control of the ANT-5 over V.24 using an
SCPI command set.

IP-Ping and Trace Route
BN4565/93.65

The following IP-Stacks are supported:

Reply-To-Ping

The unit responds to ping request.

IP-Ping

The unit generates IP-Ping requests and supports analysis of
the reply. Time to live, number of pings, delay, lost pings.

Trace Route

Reports on the IP route between the tester and the destination
device. Tabular results showing Addresses and timings.

ATM Enhancements
BN4565/93.66

This option offers significantly extended ATM capability over
option 4565/93.54. This includes:

AAL2 & AAL5 Generation and analysis

Complete cell header editing
Cell load – VBR/CBR
Analysis of the channel
Channel statistics
Insertion of errors and defects

Channel Traffic

Scans for active VPI/VCI channels and provides detailed infor-
mation on each channel:

AAL Type
Average Cell Rate
Sustainable Cell Rate
Peak Cell Rate
Total Cell Count
Cell Count CLP=0 & CLP=1
1-point Cell Delay Variation
1 point Cell Inter-arrival Time

BN4565/93.63

This is a combination option pack that provides 4565/93.64,
4565/93.65 and 4565/93.66 in a single purchase option

PLCP
BN4565/93.67

PLCP mapping into DS3 of ATM traffic Reports:-
REI – PLCP
FAS – PLCP
B1 – PLCP
FEBE – PLCP

ICMP (Ping)

= Not a supported stack

AAL-5

LLC

NLPID

SNAP

LLC

PPPoA

Ethernet II

Ethernet

PPPoE