Atec JDSU-ANT-5 - Manual (Page 10)

10
ANT-5 SDH ACCESS TESTER
Display/Language/Timer
Display
Color TFT LCD screen
Resolution
320 x 240 pixels
Languages
The user interface can be displayed in the following languages:
English, German, French, Italian, Spanish, Portuguese, and
Chinese
Measurement timer
Variable 1 second to 99 days
Measurement start Manual or delayed start timer
Measurement stop Manual or automatic timer
Display of elapsed time hh:mm:ss
Peripheral Interface
Ethernet communication port
RJ-45 Connector, 10BaseT,TCP/IP
Compact Flash Card
Compact Flash card slot Type I and II
Result/Event Presentation
Alarm notification
Most important anomalies and defects are indicated via LEDs,
on-screen graphic icons, and via an audio beeper.
LED event history
On screen soft LEDs and defect panel alarms can be set to dis-
play historical events.These are
displayed in yellow to easily distinguish them from current
alarms that are displayed in red.
OK summary display
Display of large “OK” for error-free circuits for fast and simple
installation checks. Upon detection of any anomaly or defect,
the “OK” is removed and replaced with a hierarchical list of
events, allowing for the easy diagnosis of problems. Display of
signal structure with BER or BLER displayed simultaneously.
Defect panel
On-screen hierarchical LED indication of defects.
Anomaly count
Table of all anomalies with a measured count and ratio.
Event log
Tabular display of time stamped events.
Alarm and error resolution
100 ms
Graphical display/histogram
Display of errors and alarms as bar graphs versus time.
Zoom function allows display resolution of seconds, minutes,
hours and days.
General Specifications
Results Storage/Transfer/Printing
Results storage
Results can be stored either with the internal memory or on
external memory (Compact Flash card)
Internal memory
Memory capacity up to 10,000 entries (approximately seven
days at one entry per minute)
Results export
Results can be exported to PC in .CSV format using V.24,
Ethernet (requires remote operation option BN4565/00.60), or
a Compact Flash card.These results can be processed using
standard PC software, such as Microsoft Excel or Word.
Printer interface/remote interface
– Serial V.24/RS-232
– Parallel using adapter cable K1589
– ASCII printing possible
Printing
Setups and measurement results can be printed using printers
compatible with DeskJet,ThinkJet, Epson 9, and Epson 24
printer drivers.
Powering
Power outage function
In the event of an AC line power failure during a measure-
ment, the ANT-5 continues to perform measurements using its
internal batteries.
Power supply
AC line voltage using series specific adapter
100 to 240 V
AC line frequency 50/60 Hz
Typical operating time on batteries 3 hours
Safety Classification
Safety class to IEC 1010-1 Part 1 (for connection to SELV only)
Pollution environment degree 2
Installation category II (indoor use)
Temperature Range
Ambient temperature
Nominal range of use
+5° C to +45° C
Storage/transport range –20° C to +60° C
Weight and dimensions (L x W x H)
Dimensions 275 mm x 197 mm x 76 mm
Weight 2.2 kg
Figure 13: Results page