Atec Agilent-N6030A - Manual (Page 7)

7
Sample clock
Internal
Fixed 1.25 GS/s
Internal clock output
+3 dBm nominal
External clock input
Tunable 100 MS/s to 1.25 GS/s
External clock input drive level
+5 to –15 dBm typical
Phase noise characteristics:
1 kHz : -95 dBc/Hz
10 kHz : -115 dBc/Hz
100 kHz : -138 dBc/Hz
1 MHz : -150 dBc/Hz
Noise Floor
-150 dBc/Hz
Accuracy
Same as 10 MHz timebase input
Frequency reference
Input drive level
+2 to +12 dBm into 50 Ω
(+2 dBm nominal)
Waveform length
8 MS per channel
(16 MS with Option 016)
Minimum waveform length
128 samples
Waveform granularity
8 samples
Segments
1 to 32 k unique segments can be
defined consisting of waveform start
and stop address, repetitions, and
marker enable flags.
Segment loops
A total of 1 million (2 20 ) loops can
be defined for each segment. Loops
can be configured to advance in one
of three modes:
• Single
The segment loop plays once
and waits at the end of the loop
for a trigger.
• Continuous
Segment loop is repeated
continuously until a trigger is
received.
• Auto
Automatically advances to the
next segment after completing
the specified number of loop
repetitions.
• Repeat
The waveform loop repeats until
the number of waveform loop
repetitions is met.
Sequences
Up to 32 k total unique waveform
sequences can be defined. A
sequence is a contiguous series of
waveform segments.
Advanced sequencing
Enables users to build and playback
scenarios, which are comprised of
one or more sequences.
Scenarios
1 to 16 k pointers can be assigned
to play pre-defined sequences.
Sequence play begins with the
first sequence entry and continues
uninterrupted until the last entry
is played. The table repeats until
stopped.
Key characteristics
(continued)