Atec Agilent-81133A-81134A - Manual (Page 8)

8
Clock input
Interface ac-coupled with optional dc
termination
Impedance 50 Ohm
Termination voltage –2.0 V . . +3.0 V
Minimum amplitude 300 mV, tr < 3 ns, 50% duty cycle;
sine: 6 dBm
Maximum amplitude 3 Vpp , ± 5 Vdc
Frequency measurement Yes
Period range 299 ps . . 66.6 ns
Period resolution 6 digits, 0.001 ps best case
Frequency range 15 MHz . . 3.35 GHz
Measurement resolution 100 kHz
Measurement accuracy 50 ppm
Start input
Modes Start 1
Interface dc-coupled
Impedance 50 Ohm nominal
Termination voltage –2.0 V . . 3.0 V
Transitions < 1 ns
Threshold –1.8 to +4 V
Max. level window –2 to +5 V
1. No fixed latency between assertion of start signal and start of
output signal
Figure 3.
Propagation delay
Clock input to trigger output 8.4 ns nominal, fixed
Trigger output to channel output 32 ns nominal variable
Additonal features
Remote interfaces SCPI over GPIB, LAN and USB
Store/recall registers
(Non volatile memory)
9 complete settings can be saved.
The last settings are saved when
power is turned off.
General information
Operating temperature 0 to +55 °C
Storage temperature –40 to +70 °C
Humidity 95% R.H. (0 to +40 °C)
Warm up 30 Minutes
EMC Class A
Power 100V to 240V AC nom.;
200 VA max.; 47 Hz to 63 Hz
Net weight 14.8 kg (32.6 lbs)
Shipping weight 19 kg (41.9 lbs)
Dimensions 145 x 426 x 553 (mm)
5.7 x 16.75 x 21.75 (in)
Recalibration period 3 years recommended
Jitter modulated
with rectangle-wave
Jitter modulated
with sine-wave
Jitter modulated
with noise-
generator
Variable cross over
point at 70%
33250A modulation
source
81133-34A pulse-/
pattern generator
Device under
test
Infinium
Reference
Delay control input