Atec Agilent-60504B - Manual (Page 5)

6
Range Transient Current Level Current Slew Rate Overshoot*
12 A 6 A 0.5 A/
µ
s, 1 A/
µ
s 5%
6 A 0.2 A/
µ
s to 0.2 A/
µ
s 0
12 A 1 A/
µ
s 2%
12 A 0.2 A/ms to 0.5 A/
µ
s 0
*Overshoot may be higher during the first five seconds of programming if unit has been operating at full
current. Overshoot values assume a total inductance of l
µ
H, or less, in the load leads connected to the
D.U.T.
Source Turn-On Current Overshoot: Less than 10% of final value (in CC and CR modes when connected to power
supplies with voltage rise times of greater than 500
µ
s).
Programmable Short Circuit: 0.17
Ω
(0.012
Ω
typical)
Programmable Open Circuit: 20 k
Ω
(typical)
Drift Stability (over an 8 hour interval):
Current: ±0.03% ± 20 mA
Voltage: ±0.01% ± 10 mV
Reverse Current Capacity: 120 A when unit is on; 60 A when unit is off
Weight: 5.4 kg (12 lbs.)
Table 60504-2. Programming Ranges
Function Front Panel Front Panel HPSL Command Range of Values
Key Display (Short Form)
Constant Current
Set Range C:RNG value "CURR:RANG value"
Low Range
≥
0 and
≤
12 A
High Range > l2 A and
≤
120 A
Set Main Level CURR value "CURR value"
Low Range 0 to 12 A
High Range 0 to 120 A
Set Slew Rate (shift) C:SLW value "CURR:SLEW value"
Low Range 0.0002 to 1 (A/
µ
s)
High Range 0.002 to 10 (A/
µ
s)
Set Transient Level C:TLV value "CURR:TLEV value" same as main level
*Set Triggered Level "CURR:TRIG value" same as main level
Constant Resistance
Set Range R:RNG value "RES:RANG value"
Low Range
≥
0 and
≤
0.5
Ω
Middle Range > 0.5
Ω
and
≤
500 k
Ω
High Range >500
Ω
and
≤
5 k
Ω
Set Main Level RES value "RES value"
Low Range 0 to 0.5
Ω
Middle Range 0.5
Ω
to 500
Ω
High Range 5
Ω
to 5 k
Ω