Atec Agilent-60501B - Manual (Page 5)

6
Table 60501-1 Specifications and Supplemental Characteristics (continued)
Source Turn-On Current Overshoot: Less than 10% of final value (in CC and CR modes when connected to power
supplies with voltage rise times of greater than 500
µ
s).
Programmable Short Circuit: 0.066
Ω
(0.04
Ω
typical)
Programmable Open Circuit: 20 k
Ω
(typical)
Drift Stability (over an 8 hour interval):
Current: ± 0.03% ± 5 mA
Voltage: ± 0.01% ± 10 mV
Reverse Current Capacity: 50 A when unit is on; 20 A when unit is off
Weight: 3.2 kg (7 lbs.)
Table 60501-2. Programming Ranges
Function Front Panel Front Panel HPSL Command Range of Values
Key Display (Short Form)
Constant Current
Set Range C:RNG value "CURR:RANG value"
Low Range
≥
0 and
≤
3 A
High Range > 3 A and
≤
30 A
Set Main Level CURR value "CURR value"
Low Range 0 to 3 A
High Range 0 to 30 A
Set Slew Rate (shift) C:SLW value "CURR:SLEW value"
Low Range 0.00005 to 0.25 (A/
µ
s)
High Range 0.0005 to 2.5 (A/
µ
s)
Set Transient Level C:TLV value "CURR:TLEV value" same as main level
*Set Triggered Level "CURR:TRIG value" same as main level
Constant Resistance
Set Range R:RNG value "RES:RANG value"
Low Range
≥
0 and
≤
2
Ω
Middle Range > 2
Ω
and
≤
2 k
Ω
High Range >2 k
Ω
and
≤
10 k
Ω
Set Main Level RES value "RES value"
Low Range 0 to 2
Ω
Middle Range 2
Ω
to 2 k
Ω
High Range 20
Ω
to 10 k
Ω
Set Slew Rate (shift)
Low Range V:SLW value "VOLT:SLEW value" same as voltage slew
Middle/High Range C:SLW value "CURR:SLEW value" same as current slew
Set Transient Level R:TLV value "RES:TLEV value" same as main level
*Set Triggered Level "RES:TRIG value" same as main level
Constant Voltage
Set Main Level VOLT value "VOLT value" 0 to 60 V
Set Slew Rate (shift) V:SLW value "VOLT:SLEW value" 0.001 to 0.5 (V/
µ
s)
Set Transient Level V:TLV value "VOLT:TLEV value" same as main level
*Set Triggered Level "VOLT:TRIG value" same as main level