Atec Agilent-60501B - Manual (Page 4)

5
Table 60501-1 Specifications and Supplemental Characteristics (continued)
Current Slew Rate:*
Rate # 30 A Range Step 3 A Range Step Transition Time
1 0.5 A/ms 0.05 A/s 8.0 ms
2 1.2 A/ms 0.12 A/s 3.2 ms
3 2.5 A/ms 0.25 A/ms 1.6 ms
4 5 A/ms 0.5 A/ms 800
µ
s
5 12 A/ms 1.2 A/ms 320
µ
s
6 25 A/ms 2.5 A/ms 160
µ
s
7 0.05 A/
µ
s 5 A/ms 80
µ
s
8 0.12 A/
µ
s 12 A/ms 32
µ
s
9 0.25 A/
µ
s 25 A/ms 16
µ
s
10 0.5 A/
µ
s 0.05 A/
µ
s 12
µ
s
11 1.2 A/
µ
s 0.12 A/
µ
s 12
µ
s
12 2.5 A/
µ
s 0.25 A/
µ
s 12
µ
s
*AC performance specified from 3 to 60 V.
Voltage Slew Rate:
Rate # Voltage Range Step Transition Time*
1 1 V/ms 8.0 ms
2 2.5 V/ms 3.2 ms
3 5 V/ms 1.6 ms
4 10 V/ms 800
µ
s
5 25 V/ms 320
µ
s
6 50 V/ms 160
µ
s
7 0.1 V/
µ
s 85
µ
s
8 0.25 V/
µ
s 85
µ
S
9 0.5 V/
µ
s 85
µ
S
*Transition time based on low capacitance current source.
Resistance Slew Rate (2
Ω
range): Uses the value programmed for voltage slew rate.
Resistance Slew Rate (2 k and 10 k
Ω
ranges): Uses the value programmed for current slew rate.
Transient Current Overshoot (When programmed from 0A):
Range Transient Current Level Current Slew Rate Overshoot*
30 A 3-30 A All slew rates 0
1.5 A 0.5 A/
µ
s to 2.5 A/
µ
s 6%
1.5 A 0.5 A/ms to 0.25 A/
µ
s 0
3 A 3 A All slew rates 0
1.5 A 0.13 A/
µ
s and 0.25 A/
µ
s 3%
1.5 A 0.05 A/ms and 0.05 A/
µ
s 0
*Overshoot may be higher during first five seconds of programming if unit has been operating at full current. Overshoot
values assume a total inductance of l
µ
H, or less, in the load leads connected to the D.U.T.