Atec Agilent-infiniium-90000 Series - Manual (Page 30)

30
InfiniiMax II Series
Performance characteristics
1169A, 1168A
Bandwidth* 1169A: > 12 GHz (13 GHz typical) 1168A: > 10 GHz
Rise and fall time
Probe only
When phase compensated by
90000A Series oscilloscope
1169A: 28 ps (20 - 80%), 40 ps (10 - 90%) 1168A: 34 ps (20 - 80%), 48 ps (10 - 90%)
1169A w/91204A: 25 ps (20 - 80%) 1168A w/90804A: 38 ps (20 - 80%)
36 ps (10 - 90%) 54 ps (10 - 90%)
1169A w/91304A: 23 ps (20 - 80%)
33 ps (10 - 90%)
System bandwidth (–3 dB) 1169A w/91304A: 13 GHz (typical) 1168A w/90804A: 8 GHz
1169A w/91204A: 12 GHz
Input capacitance 1 Cm = 0.09 pF Cm is between tips
Cg = 0.26 pF Cg is to ground for each tip
Cdiff = 0.21 pF Differential mode capacitance = Cm + Cg/2
Cse = 0.35 pF
Single-ended mode capacitance = Cm + Cg
Input resistance* Differential mode resistance = 50 kΩ ± 2%
Single-ended mode resistance = 25 kΩ ± 2%
Input dynamic range 3.3 V peak to peak, ± 1.65 V
Input common mode range 6.75 V peak to peak dc to 100 Hz; 1.25 V peak to peak > 100 Hz
Maximum signal slew rate 25 V/ns when probing a single-ended signal
40 V/ns when probing a differential signal
DC attenuation 3.45:1
Zero offset error referred to input ± 1.5 mV
Offset range ± 16.0 V when probing single-ended
Offset gain accuracy < ± 1% of setting when probing single-ended
Noise referred to input 2.5 mV rms, probe only
Propagation delay ~6 ns (this delay can be deskewed relative to other signals)
Maximum input voltage 30 V peak, CAT I
ESD tolerance > 8 kV from 100 pF, 300 Ω HBM
Temperature Operating: 5 °C to +40 °C
Non-operating: 0 °C to +70 °C
* Denotes warranted specifications, all others are typical.
1 Measured using the probe amplifier and N5381A solder-in differential probe head.